Riscaldamento a pavimento EFH
Ensto floor heating cables are an economical, convenient and long-lasting way of heating your home. It is easy to install, easy to use and it does not leak or use too much energy. The floor feels pleasant and dries quickly. Tassu Floor Heating has obvious advantages in rooms with tiled floor but it can also be used to heat wooden floors. When there's a limited possibility to raise the floor surface (e.g. when renovating facilities) Ensto's TassuS is an excellent solution.
Tassu-cavo scaldante sottopavimento | |
By using TASSU underfloor heating cables, a direct or partial storage floor heating can be carried out. The direct underfloor heating is used in wet or damp areas, where the floormaterial is low thermal resistant, e.g. clinker. The direct underfloor heating is suitable also in other areas as the only heating form. The partial storage underfloor heating is used for example in living rooms and kitchens. The output per square meter should be 80-150 W/m², the installation distance 13 – 25 cm and the installation depth 5-10 cm. The heating cable is a preterminated twin-conductor cable with a PVC sheath. The lowest installation temperature is -10°C. The output of the cable is 20W/m with a nominal voltage of 230V. The heating cable is supplied with a cold lead of 2.5 meter. | |
Tassu S -underfloor heating cables | |
The TASSU S underfloor heating cables are used in plasterboard floors, wooden floors and in renovation, where the cable is installed on top of the old floor. The output per square meter should be 60 – 110 W/m², the installation distance 9 – 17 cm and the installation depth 2.5 cm. The heating cable is a preterminated twin-conductor cable with a PVC sheath. The lowest installation temperature is -10 °C. The output of the cable is 10W/m with a nominal voltage of 230V. The heating cable is supplied with a cold lead of 2.5 meter. | |
Fixing equipment | |
Cable fixing strip XBC1230 is used for fixing the underfloor heating cable. | |
ThinMat-underfloor heating mat – 100 W/m² with thermostat | |
Lower power per square meter, 100 W/m², is sufficient for comfort heating in dry and damp indoor conditions and it should be installed to thin layer of levelling compound. Wood, parquet, laminate, concrete, stone or clinker can be used for surface material. Suitable for installation on top of chipboard, but have to be covered with levelling compound. The package includes a floor heating mat, floor heating thermostat, adhesive aluminium tape, a sensor and a flexible installation tube for the sensor. The temperature range of the thermostat ECO10FSJ+E is 10 - 35 °C, IP31. The rated voltage is 230 V. Lowest installation temperature, + 5 °C. ThinMat width is 48 cm. The length of the cold lead is 4 m. |
